GMS-214 Multimode Filter

15 Different Filter Modes and VC Resonance

This multimode filter has two signal inputs mixed at unity gain and allows selection of one of fourteen possible filter configurations from front panel switches. If the resonance control is set high enough, the filter will start to oscillate.

 Three CV inputs are provided. A 1V/Octave input controls the filter cutoff frequency in conjunction with the panel frequency control. A second frequency CV input has a level control, the resulting voltage being added to or subtracted from the base cutoff frequency resulting from the panel frequency control and 1V/Oct inputs. A resonance CV input followed by an attenuverter is combined with the panel resonance control to determine the amount of resonance that will occur. If the resonance control ia turned past about 80, the filter will start to oscillate with a clean sine waveform.

The Eurorack version is housed in a 12HP (2.4 inch wide by 5.03 inch high) panel with Eurorack 16 pin power connector.


FILTER MODE CHART

POLES MODE +1P LP
1P Lowpass  
1P Highpass  
2P Lowpass  
2P Bandpass  
2P Band Notch  
2P Band Notch +1PLP
2P Highpass  
2P Highpass +1PLP
3P Lowpass  
3P Highpass  
3P Highpass +1PLP
3P Allpass  
3P Allpass +1PLP
4P Lowpass  
4P Bandpass  

Technical Specifications


Filter topology
Multimode 1 to 4 poles
Lowpass, Bandpass, Highpass, All Pass, Band Notch


Frequency Range
22Hz - 20KHz

Typical Input Impedance - each input
100K Ohms

Typical Output Impedance
1K Ohms (short circuit protection)

Frequency control inputs
2 - Input 1 fixed 1V/Octave,
Input 2 with level control

Resonance control input
1 - Input with attenuverter

Module Power
+12 Volts 35 mA.
-12 Volts 25 mA.
+5 Volts 100 mA.

Module Size
Panel height - 5.03 inches (128 mm)
Panel width - 2.4 inches (61 mm)
Depth (behind panel) 2.1 inches (53 mm)

275.00



ELECTRONIC SYNTHESIZERS

We produce electronic synthesizer modules in the two most popular formats, MU (Moog compatible 5U) and EU (Eurorack compatible 3U). A wide range of voltage controlled modules including oscillators, amplifiers, mixers, envelope generators, special effects units, wave generators, filters, power systems and cases allow users complete freedom to configure any desired electronic music instrument.

PROFESSIONAL AUDIO EQUIPMENT

Grove Audio builds microphones, preamplifiers, equalizers, compressors and other professional audio equipment for performance and studio use. We build units in popular formats such as 19 inch rack mount and 500 series 3U modules. We can also produce custom designs on request. Contact us for a consultation.

GROVE SYNTH STORE

You can explore all of our products, download spec sheets, and purchase our products in the Grove Audio Synth Store. You can also learn about our periodic specials and new product introductions. Click the button below to go directly to the store.

Follow Us!

Grove Audio Help
Contacts
  • Email: sales@groveaudio.com
  • Phone: 608 886-6503

About

Grove Audio has been manufacturing professional recording and modularized electronics for musicians and performers since 1995.

Social